MONTÖR İÇİNДЛЯ УСТАНОВИТЕЛЯTIL INSTALLATØRENFÖR INSTALLATÖRENPARA O INSTALADORΓΙΑ ΑΥΤΟΝ ΠΟΥ ΚΑΝΕΙ ΤΗΝ ΕΓΚΑΤΑΣΤΑΣΗPER L’INSTALLATOREPARA EL INSTALADORV
106.3. Wiring transmission cables1 Types of control cables1. Wiring transmission cables• Types of transmission cables: Shielding wire CVVS or CPEV
11Cross-sectional area of Wire for Main Power Supply and On/Off CapacitiesModelPower SupplyMinimum Wire Cross-sectional area (mm2)Breaker for Wiring *
121. Use a separate power supply for the outdoor unit and indoor unit.2. Bear in mind ambient conditions (ambient temperature,direct sunlight, rain
137.2. Test run7.2.1. Using remote controller Refer to the indoor unit installation manual.• Be sure to perform the test run for each indoor unit.
2 Warning:• The unit must not be installed by the user. Ask a dealer or an authorized technician to install the unit. If the unit is installed
31. Safety precautions1.3. Before electric work Caution:• Be sure to install circuit breakers. If not installed, electric shock may result.• For t
42. Installation location2.1. Refrigerant pipeRefer to Fig. 4-1.2.2. Choosing the outdoor unit installation location• Avoid locations exposed to d
52. Installation locationFig. 2-4Fig. 2-8Fig. 2-9Fig. 2-10Fig. 2-11 Fig. 2-12Fig. 2-13 Fig. 2-14 Fig. 2-15Fig. 2-7Fig. 2-6Fig. 2-5Fig. 2-315020030020
62.5.3. Windy location installationWhen installing the outdoor unit on a rooftop or other location unprotected from the wind, situate the air outlet
74.2. Connecting pipes (Fig. 4-2)Fig. 4-1 is a sample of piping system.• Conductsufcientanti-condensationandinsulationworktopreventwaterdr
84. Installing the refrigerant piping4.3. Refrigerant piping (Fig. 4-4)Remove the service panel D (three screws) and the front piping cover A (two s
94. Installing the refrigerant piping5. Drainage piping workOutdoor unit drainage pipe connectionWhen drain piping is necessary, use the drain socke
Comentarios a estos manuales