Mitsubishi Electric ZRP35 Manual de instalación

TIL INSTALLATØRENFÖR INSTALLATÖRENPARA O INSTALADORPER L’INSTALLATOREPARA EL INSTALADORVOOR DE INSTALLATEURPOUR L’INSTALLATEURFÜR INSTALLATEUREFOR INS

S1S2S3S1S2S3106.2. Field electrical wiringOutdoor unit modelZRP35, 50V ZRP60, 71V ZRP100,125V ZRP140V ZRP100, 125, 140YOutdoor unit power supply ~/N (

11Caution:Make sure to perform the “7. Test run” and confirm the unit works without any problems, before starting the following settings.► How to selec

121234569.1. Low noise mode (on-site modification) (Fig. 9-1)By performing the following modification, operation noise of the outdoor unit can bereduced

2Contents1. Safety precautionsAfter installation work has been completed, explain the “Safety Precautions,” use, and maintenance of the unit to the cu

31. Safety precautions1.2. Before installation (relocation) Caution:• Be extremely careful when transporting or installing the units. Two or more pe

42. Installation location 2.4. Ventilation and service space2.4.1. Windy location installationWhen installing the outdoor unit on a rooftop or other l

5Fig. 3-13. Installing the outdoor unit• Be sure to install the unit in a sturdy, level surface to prevent rattling noises during peration. (Fig. 3-1

90° ±0.5°øAR0.4 - R0.845°± 2 °64.2. Connecting pipes (Fig. 4-1)• When commercially available copper pipes are used, wrap liquid and gas pipes with co

74. Installing the refrigerant piping Stop valve <Liquid side> Stop valve <Gas side> Service port Open/Close section Local pipe

8Perform the airtight test, vacuum air purging, additional refrigerant charging (if necessary), and gas leak check.4.7. Precautions when reusing exist

S3S3S2S1S2S1LN96. Electrical work6.1. Outdoor unit (Fig. 6-1, Fig. 6-2)  Remove the service panel.  Wire the cables referring to the Fig. 6-1 an