Mitsubishi Electric PKFY-P.NFMU-E Manual de instalación

INSTALLATION MANUALFor safe and correct use, please read this installation manual thoroughly before installing the air-conditioner unit.Air-Conditione

10EDBCACBDF1-3/8 (35)17-11/16 (449)22-7/8 (581)11-1/32 (280)1-7/32(31)2-1/8 (54)3-3/8 (86)6-1/32 (153)27-9/16 (700)4.3. Positioning refrigerant and dr

11Working process PKFY-P06/P08NAMU-E (Fig. 4-8)1. Remove the flare nut and cap of the indoor unit.2. Make a flare for the liquid pipe and gas pipe an

12 PKFY-P12/P15NGMU-E (Fig. 5-2)Preparing left and left rear pipingThe drain hose can be connected at two different positions. Use the most convenien

135.3. Drain check (Fig. 5-7)Pour water in the drainpan and check that it comes out the drain pipe end, afterconfirmation, reinstall the panel.5. Drai

14 PKFY-P18/P24/P30NFMU-E (Fig. 6-3)1. Remove the right-side panel.2. Install each wire into the unit.3. Remove the tapping screw (1), and then remov

15Types of control cables1. Wiring transmission cables: Shielding wire CVVS or CPEVS• Cable diameter: More than 1.25 mm2 (AWG16)2. M-NET Remote contro

167. Test run7.1. Before test runs After completing installation and the wiring and piping of the indoor andoutdoor units, check for refrigerant leaka

21.2. Before installation or relocation Caution:• Be extremely careful when transporting the units. Two or more persons areneeded to handle the unit,

Please be sure to put the contact address/telephone number onthis manual before handing it to the customer.This product is designed and intended for u

32. Installation location2.1. Installation location• Mount the indoor unit on a wall strong enough to withstand the weight of the unit.• Select a loca

43. Installing the indoor unit PKFY-P12/P15NGMU-E (Fig. 3-2)PARTNUMBERACCESSORY QUANTITY LOCATION OF SETTING¡ Mount board 1Fix at the back of the uni

538-31/32 (990)9-21/32 (245)11-7/32 (285)17-29/32 (455)13/32×3-19/32= (35-13/16)(10×91= (910))3/4 (19)13/32 (10)7-1/4 (184)11-1/32 (280)2-3/8 (60)1-3/

63) Installing the mount board (the wall-fixing bracket) (Fig.3-8)s Selection of the mounting location requires thorough consideration. If thewall doe

73.5. Mounting the indoor unit (Fig. 3-11)1. Securely place the hanging fixtures for the indoor unit over the catches on themount board.A Indoor unitB

83.10. Preparation for piping connectionRemove the vinyl band that holds the drain piping.• This vinyl band can be used to temporarily attach the pipe

94. Installing the refrigerant pipingA Flare cutting dimensionsCopper pipe O.D.Flare dimensions øA dimensions1/4" (ø6.35) 11/32-23/64 (8.7 - 9.1)