Installation Manual For INSTALLER• This manual only describes the installation of outdoor unit. When installing the indoor unit, refer to the install
En-11. BEFORE INSTALLATION1-1. THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFETY• Be sure to read “THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFET
En-23. Obstacles in front (blowing) onlyWhen there is an obstacle in front of theunitasshowninthegure,openspace above, behind, and on the s
En-31-5. INSTALLATION DIAGRAMUnits should be installed by licensed contractor according to local code requirements.After the leak test, apply insulat-
En-42. OUTDOOR UNIT INSTALLATION2-1. INSTALLING THE UNIT2-2. CONNECTING WIRES FOR OUTDOOR UNIT35 mm15 mmLead wire• Be sure to attach each screw to it
En-54-1. PURGING PROCEDURES AND LEAK TESTFig. 1 Fig. 2Fig. 3 Fig. 4Fig. 5 Fig. 63. FLARING WORK AND PIPE CONNECTION3-1. FLARING WORKPipe diameter (mm
En-64-3. LOCKING THE OPERATION MODE OF THE AIR CONDITIONER (COOL, DRY, HEAT)4-4. LOWERING THE OPERATION NOISE OF THE OUTDOOR UNIT4-2. GAS CHARGEPerfor
En-74-6. TEST RUN• Test runs of the indoor units should be performed individually. See the installation manual coming with the indoor unit, and make s
Comentarios a estos manuales