Mitsubishi Electric PMFY-P.VBM-E Manual de instalación

Air-Conditioners For Building ApplicationINDOOR UNITPMFY-P•VBM-EINSTALLATION MANUALFor safe and correct use, read this manual and the outdoor unit ins

Please be sure to put the contact address/telephone number on this manual before handing it to the customer.This product is designed and intended for

GB2► Beforeinstallingtheunit,makesureyoureadallthe“Safetyprecau-tions”.► Pleasereporttoyoursupplyauthorityorobtaintheirconsentb

GB32. Installation location2.2.Servicespace(Fig.2-2)• The dimensions of ceiling opening can be regulated within the range shown in following

GB42. Installing the indoor unitCheck the pitch of the suspension bolt. (340 mm × 811 mm)1. Thread washers 1 2 (supplied) and their nuts (procured

GB53. RefrigerantpipeanddrainpipeFig. 3-2Installing procedures (Fig. 3-3)1. Remove the are nuts and caps from the indoor unit.2. Flare-cut t

GB63. RefrigerantpipeanddrainpipeIncasesofupwarddrainage(Fig.3-7)• The largest dimension possible for the vertical section at B is 60

GB74. Electricalwork5. Installing the grilleFig. 5-14.5. Settingaddresses(Fig.4-4)(Be sure to operate with the main power turned OFF.)• Ther

GB85.3.Installingthegrille(Fig.5-4)• Open the intake grille by pressing on the place marked Push, and remove the air lter.• Remove the screw cov

GB9Fig.6-1°C°CSIMPLEPAR-21MAAON/OFFFILTERCHECKOPERATIONCLEARTESTTEMP.MENUBACK DAYMONITOR/SETCLOCKON/OFFTEST RUNCOOL, HEAT  "!  A ON/O